REELCRAFT LC312 103 1 Cord Reel 200 Feet 10/3 Red

Reelcraft LC312 103 1 cord reel provides a convenient and organised solution for storing and dispensing electrical cords, cables or hoses. It helps to minimise clutter, prevent tangling and protect cords from damage. This reel is used in workshops, manufacturing facilities and construction sites.

Features:

• It features heavy-gauge steel construction for structural rigidity and long service life.
• This cord reel has self-locking fasteners to ensure assembly integrity.
• It comes with individually powder-coated components, providing maximum protection against premature corrosion and ensuring a quality finish.
• This 200-foot extension cord reel has a heavy-duty collector ring, ensuring maximum conductivity and current flow.

Frequently Asked Questions:

Q. What wire size can this Reelcraft 200-foot extension cord reel accommodate?

A. This cord reel can accommodate a wire size of 10 AWG.

Q. What safety precautions should be taken when choosing Reelcraft cord reels?

A.

• Only allow a qualified electrician to install or service this equipment.
• Ensure that the power supply voltage does not exceed the maximum voltage rating of the reel.
• Properly install the reel before connecting it to the power supply.
• Remove all electrical power from the reel before servicing.
• Before each use, check for frayed or broken wires.
• When pulling the electrical cord from the reel, grasp the cord itself, not the work device.
• If an electrical malfunction occurs, immediately remove power from the reel.
• Ensure that the reel, electrical cable and equipment being serviced are properly grounded, and use an ohmmeter to check ground continuity.
• If the reel stops unwinding or rewinding, immediately remove the power and avoid pulling or jerking on the electrical cable.
• Treat the hose reel with the same level of caution as any other piece of machinery, observing all common safety practices.

Q. How to install the output cable for Reelcraft LC312 103 1 cord reel?

A.

• Remove the 4 screws holding the spool cover.
• Loosen the screws on the 90 degrees strain relief and feed approximately 18 inches through.
• Now, tighten the screws and then feed the cord through the shaft and replace the spool cover.
• Connect the output wire to the collector ring wire leads following NEC recommendations, avoiding knife disconnects.
• Replace the collector ring cover and tighten the nuts.